Manual.ly Logo

Krups EA8170 Arabica Display Manual

0,0 · 0 Valoraciones

Manual en PDF · 74 Páginas

Español

M: QW-35-FL
página

/ 74

Loading...
7bc8af95ffe4a88f6dd7a70041aa269ac001 page f
25
24
■A screen indicates that the appliance is heating up. Once the appliance has finished heating up, you can begin to
make steam by pressing START
, and following these steps (13):
Step 1: holding the milk jug in place, insert the steam nozzle approximately 2 cm into the milk and wait for it to
start frothing.
Step 2: raise the container slightly (approximately 1 cm). Do not completely submerge the metal tube.
Step 3: gradually lower the container as the froth accumulates. (14)
■When you have frothed the milk enough, press the STOP button
to stop the cycle. Warning: the cycle does not
stop immediately.
■To remove any milk traces from the steam nozzle, place a container under the nozzle and start the steam function
again (approximately 10 seconds).
■The steam nozzle is removable in order to allow for deep cleaning. Wash it with water and a little non-abrasive
detergent using a brush. Rinse and dry (15-16). Before replacing, make sure that the air holes are not clogged with
milk residue. Unclog the holes with the needle supplied with your appliance if necessary (17).
■To stop the steam, press the STOP button
.
WARNING: THE CYCLE DOES NOT STOP IMMEDIATELY.
Steam can be produced for a maximum of 2 minutes per cycle.
Auto-cappuccino XS 6000 set (sold separately)
■This auto-cappuccino accessory enables you to make cappuccinos or lattes (18). Connect the different parts to
each other. Ensure that the pipe is not pierced by keeping the knob in the correct place.
■After removing the lid, fill the jug with milk (19) and place a cup or glass under the auto-cappuccino nozzle (20).
Select cappuccino or latte on the special nozzle (21).
■Start steam, as indicated in the chapter Making drinks with steam.
■Once you have made the milk froth, place your cup under the coffee jets and start a coffee cycle (22).
To prevent the milk from drying on the auto-cappuccino accessory, ensure that you clean it thoroughly. You are advised
to wash it immediately by running a steam cycle with the accessory jug filled with water in order to clean the inside
of the nozzle. For this you can use the KRUPS liquid detergent available separately.
Emptying the coffee grounds collector and the drip tray
■If the
symbol starts flashing, empty and clean the drip tray (the drip tray may contain coffee grains) and the coffee
grounds collector (23-25).
■The drip tray is fitted with floats which indicate when it needs to be emptied (26). Once you have removed the coffee
grounds collector, you should empty it completely in order to avoid any overflow.
■The warning message will continue to be displayed if the coffee grounds collector is not pushed in or inserted
correctly (24). You cannot make an espresso or a coffee while the warning message is shown.
Rinsing the circuits :
Press the maintenance and settings button
(27). The function indicator is shown above the maintenance button
.
If necessary, using the navigation button,
select the rinse symbol .
Press START , rinsing starts and finishes when the coffee menu appears.
MAINTAINING YOUR APPLIANCE
Preparing the grinder
You can adjust the strength of your coffee by adjusting how finely the coffee beans are ground.
Generally, the finer the coffee is ground, the stronger and creamier the coffee will be, but this also depends on the
type of coffee used.
Adjust the fineness of grinding by turning the coffee grounds fineness adjustment knob
which is located in the
coffee bean container. It is advised that you do this during grinding, one notch at a time.
After 3 rounds, you will notice a pronounced difference in taste. To the left, the grounds are finer. To the right, the
grounds are courser. (7)
Claris F 088 - Aqua Filter System cartridge (Sold separately)
To optimise the taste of your drinks and the lifespan of your appliance, you are advised to only use a Claris - Aqua
Filter System cartridge with your machine (see the chapter OTHER FUNCTIONS – Installing the filter).
Every time you place a Claris-Aqua Filter into the machine you must prime the filter before using the machine by
activating the “install filter cartridge” program.
Note :
The amount of water for making an espresso is between 30 and 70 ml.
The amount of water for making a coffee is between 80 and 180 ml.
Starting preparation (with 1 or 2 cups)
■Press the on-off button
, and wait for the appliance to finish heating up.
■The coffee types menu is displayed. The function indicator is shown above the coffee types button (6).
■Place one or two cups under the coffee jets. You can lower or raise the coffee jets according to the size of your cup
(8). Select the coffee strength (shown coffee beans displayed on the screen in brackets) with the + button to
increase or the - button to decrease. (9).
■Press the navigation button to set the volume: select the volume of water displayed on the screen between
brackets using the + or - buttons (10).
■Press the navigation button
to set the number of cups: select 1 or 2 cups, displayed on the screen between
brackets using the + or - buttons
.
■Press the START button
(11).
■You can set the water volume at any time using the + or - buttons .
■To stop the flow into your cup, press the STOP button
.
■You can also adjust the temperature of your coffee (see the chapter OTHER functions - Settings).
Two cup function
The appliance will automatically carry out 2 full cycles of coffee preparation.
MAKING AN ESPRESSO AND A COFFEE
Steam is used to froth the milk, for example when preparing a cappuccino or caffe latte, and also to heat up liquids.
As a higher temperature is required when producing steam than when making an espresso, the appliance will launch
an additional pre-heating phase.
Frothing milk
■For best results, you are advised to use very fresh, very cold pasteurised or UHT milk, recently opened. Unpasteurised
milk does not produce the best results.
■Check that the steam nozzle is correctly positioned.
■Pour the milk into a milk jug which has a handle or into a cappuccino cup. Only fill it half way.
■When the screen displays the drink selection menu, press the steam button
(12). The function indicator is
located above the steam button
.
■Insert the steam nozzle into the milk.
MAKING DRINKS USING STEAM

Chatee con su manual de Krups EA8170 Arabica Display usando IA

Obtenga respuestas instantáneas de IA de su manual de Krups EA8170 Arabica Display

Pregunte lo que quiera sobre Krups EA8170 Arabica Display. Las respuestas provienen de este manual, con las páginas en las que se basan.

EA8170 Arabica Display Programa de mantenimiento

Recuérdame cuándo corresponde realizar el mantenimiento
Cada 2 meses
Reemplazar el cartucho del sistema de filtro Claris Aqua

El cartucho tiene un mecanismo de fecha que indica el reemplazo después de un máximo de 2 meses para garantizar el sabor óptimo y la vida útil de la máquina.

Mostrar en el manual (página 17)
Cuando lo indique la máquina
Ejecutar programa de limpieza automática con tableta KRUPS

Inserte la tableta de limpieza KRUPS en el embudo. Llene el depósito de agua hasta el nivel máximo. Coloque un recipiente de 0,6L debajo de las boquillas e inicie el ciclo.

Mostrar en el manual (página 16)
Cuando lo indique la máquina
Ejecutar programa de descalcificación con sobre KRUPS

Retire el cartucho del filtro si está instalado. Añada un sobre de descalcificador KRUPS al depósito de agua hasta la marca CALC. Ejecute el programa completo.

Mostrar en el manual (página 16)
Después de cada uso o cuando esté lleno
Vaciar el colector de posos de café y la bandeja de goteo

Vacíe y limpie ambos componentes cuando el símbolo de advertencia parpadee o los flotadores indiquen que están llenos. Vuelva a instalarlos correctamente para evitar errores.

Mostrar en el manual (página 15)
Después de usar el vapor
Limpiar la boquilla de vapor y destapar los orificios de aire

Ejecute un breve ciclo de vapor sobre un recipiente para eliminar los restos de leche. Retire la boquilla para una limpieza profunda con cepillo y aguja si está obstruida.

Mostrar en el manual (página 15)
Si no se usa durante varios días
Enjuagar los circuitos hidráulicos

Realice un enjuague manual a través del menú de mantenimiento para eliminar el agua estancada de los circuitos de café y vapor antes de preparar.

Mostrar en el manual (página 14)

Recordatorios de mantenimiento gratuitos

Según la fecha de compra. Siempre gratis, cancela la suscripción cuando quieras.

Al enviar, aceptas la política de privacidad. Cancela la suscripción con un clic en cualquier correo electrónico.
M: qwen/qwen3.8-flash

Haz una Pregunta

0/1000

¿Recomiendas EA8170 Arabica Display?

Sí No

Preguntas frecuentes

A

Puedes ajustar la fuerza girando el pomo de finura dentro del contenedor de granos. Girar a la izquierda hace que la molienda sea más fina para un café más fuerte, mientras que girar a la derecha la hace más gruesa para un café más suave.

¿Esta respuesta fue útil?

A

Para obtener los mejores resultados, usa leche pasteurizada o UHT muy fresca y fría. Evita la leche cruda ya que no produce una consistencia de espuma óptima.

¿Esta respuesta fue útil?

A

La máquina te avisará cuando sea necesaria la limpieza. Se recomienda ejecutar el programa de limpieza mensualmente o siempre que parpadee la luz indicadora para mantener la higiene.

¿Esta respuesta fue útil?

A

Sí, la máquina tiene una función de dos tazas que ejecuta automáticamente dos ciclos de preparación completos consecutivamente para servir dos tazas simultáneamente.

¿Esta respuesta fue útil?

A

Asegúrate de precalentar tus tazas con agua caliente. También puedes aumentar la configuración de temperatura del café en el menú de mantenimiento si el nivel predeterminado es demasiado bajo.

¿Esta respuesta fue útil?

M: QW-35-FL

Ventajas y Desventajas

Ventajas

  • El sistema compacto de termobloque asegura un calentamiento rápido y eficiencia energética
  • La bomba de 15 bares entrega crema auténtica en cada shot
  • La pantalla LCD intuitiva simplifica la navegación y la programación
  • El molinillo de cono metálico proporciona frescura consistente para todos los tipos de granos
  • Los ciclos de limpieza y descalcificación automatizados reducen el esfuerzo manual
VS

Desventajas

  • La varita de vapor requiere técnica de espumado manual para una textura óptima
  • La capacidad del tanque de agua puede requerir rellenos frecuentes para usuarios intensivos
  • Accesorios opcionales como el conjunto auto-cappuccino vendidos por separado
  • El ajuste de la molienda debe hacerse mientras la máquina está funcionando para mayor precisión
  • El ciclo de descalcificación requiere productos específicos de KRUPS para los mejores resultados
M: QW-35-FL

Producto Especificación

Potencia

1948,25 W

Color

negro

Presión de la bomba

15 bar

Sistema de café

granos enteros

Sistema de leche

no

Molino

molino cónico ajustable (3 ajustes)

Cantidad de café

ajustable

Cantidad de agua

ajustable

Temperatura del café

ajustable (3 ajustes)

Capacidad del depósito de agua

1,7 L

Capacidad del depósito de granos

0,26 kg

Pantalla

sí

Características

boquilla de bebida doble altura ajustable, apagado automático, boquilla de vapor, espumador de leche (Cappuccinatore), función de agua caliente, filtro de agua integrado, programa de limpieza automática, programa de descalcificación automática

Dimensiones

38,1x48,4x28,7 cm (AnxPxAl)

Peso

7 kg

M: QW-35-FL

Producto Descripción

Descubre la Krups EA 8170 Arabica Display Negro Experiencia Manual

Bienvenido al mundo de la excelencia en el café casero con la Krups EA 8170 Arabica Display Negro. Esta máquina de espresso automática está diseñada para aquellos que exigen un café de calidad de restaurante sin salir de su cocina. El dispositivo cuenta con un Sistema Compacto de Termobloque y una potente bomba de 15 bares, asegurando que cada taza de ristretto, espresso o café se extraiga a la temperatura perfecta con máximo aroma.

La pantalla LCD fácil de usar te guía paso a paso, desde preparar tu bebida favorita hasta realizar el mantenimiento esencial. Tienes control total sobre el volumen, la intensidad y la temperatura, lo que te permite personalizar cada bebida según tus preferencias exactas. Ya sea que desees un espresso fuerte o un cappuccino cremoso usando la varita de vapor, esta máquina ofrece resultados consistentes. El molinillo de metal asegura que los granos frescos se muelan justo antes de la extracción, preservando los aceites ricos y los sabores que definen una gran taza de café.

El mantenimiento es sencillo gracias a programas automatizados para enjuagar, limpiar y descalcificar. La máquina te avisa cuando necesita atención, asegurando longevidad y rendimiento óptimo. Con su elegante diseño negro e interfaz ergonómica, la Krups EA 8170 se integra perfectamente en cualquier cocina moderna mientras ofrece funcionalidad de grado profesional.

Notas clave para usuarios

  • Siempre precalienta tus tazas de porcelana para la mejor temperatura del espresso y la crema.
  • Usa agua fría de grifo fresca libre de cloro para un sabor superior.
  • Ajusta el pomo de finura de molienda durante la molienda para obtener la configuración más precisa.
  • Limpia la boquilla del vapor inmediatamente después de usarla para evitar la acumulación de residuos de leche.
  • Utiliza el cartucho de filtro Claris Aqua opcional para prolongar la vida útil de la máquina y mejorar el sabor.
M: QW-35-FL

© Copyright 2026 Manual.ly