Manual.ly Logo

Cadac Citi Chef 50 Manual

0,0 · 0 Valoraciones

Manual en PDF · 94 Páginas

Español

M: QW-35-FL
página

/ 94

Loading...
0c86dfe032cb88893104cd4ca1dcae5c1502 page 6
44
5. Fitting and Changing the Hose and Gas Cylinder
• NOTE! When installing the tailpiece, ensure it is held straight while tightening the tailpiece
nut, in order to prevent a possible gas leak. Tighten with a suitable spanner. (Fig. 10)
• I 3B/P (30), I 3B/P (37) and I 3+ (28-30/37) Appliance categories: Fit the valve tailpiece
onto the valve by screwing it on in an anti-clockwise direction. Push an approved hose
onto the valve tailpiece until it is properly seated. On the other end, attach a suitable
low pressure regulator (I3B/P (30) : 30 mbar G30/G31 congurations regulator; I3+(28-
30/37): 28~30 mbar G30 regulator or 37 mbar G31 regulator); I3B/P(37): 37 mbar G30/
G31 congurations regulators). Again making sure that the hose is well seated. The type
of hose used shall comply with the relevant EN standard and local requirement. In South
Africa the regulator used must comply with SANS 1537.
• I 3B/P (50) Appliance category: Screw a Hose with the correct threaded ttings on each
end, onto the left hand ¼“ BSP thread of the Valve. Attach a suitable 50 mbar G30/G31
low-pressure regulator on the other end of the hose. The hose used must comply with DIN
4815 part 2 or equivalent.
• The hose length should be no less than 800mm and shall not exceed 1.5m. Check the manufacture date on the hose and replace
when necessary or when national regulations require it.
• Do not twist or pinch hose. Ensure the hose does not come into contact with any surfaces that would become hot during use.
• Before tting the regulator to a gas container, ensure that the seal on the regulator is in position and in good condition. This should be
done with every connection and before every use.
• Before tting your gas cylinder, ensure that the valves are all in the “OFF” position by turning the control knob clockwise to its stop.
• Ensure that the gas container is tted or changed in a well-ventilated location, preferably outdoors, away from any source of ignition
such as naked ames or electric res and away from other people.
• Making sure that the gas container is kept upright, screw the regulator onto the container until it is fully engaged. Hand-tighten only.
• If there is a leak on your appliance (smell of gas), close the cylinder valve immediately and follow the procedure to detect and stop a
leak under Section 3. If you wish to check for leaks on your appliance, do it outside using soapy water only, which is applied to the
joints. A formation of bubbles will indicate the gas leak.
• Check that all the connections are securely tted and re-check with soapy water. If you cannot rectify the gas leak, do not use the
appliance. Contact your local CADAC stockist for assistance.
• When changing a gas container, rstly close the container valve (if tted) and then turn the control knob clockwise to its stop position.
• Ensuring that the ame is extinguished, unscrew the regulator. Ret a full container following the same precautions as described
above.
6. Lighting the appliance
Precautions to observe before lighting.
• After prolonged storage, inspect the air holes in the valve cover for insects, which may affect gas ow. Inspect the inlet of the venturi
for insects. After checking, ret all components into the prescribed position.
• Use this appliance only on a rm level surface.
Using the control knob
The control knob is tted with two positive stop positions, one at low, and one at Ignite / High. This limits the adjustment of the ame
to between these two points.
Lighting up using the Piezo Igniter
• To light up the appliance using the piezo igniter, push in and turn the control knob in an anti-clockwise direction until you hear a
click. If the gas does not ignite on the rst spark, push in, and turn the control knob fully clockwise. Try again, by pushing in and
turning the control knob anti-clockwise until you hear a click. If the gas has not ignited in the rst two to three seconds you should
close the control valve by pushing in the control knob, and turning it fully clockwise. Wait approximately thirty seconds to let any
accumulated gas within the burner pan assembly escape. Repeat the above process if necessary until the ame ignites. The ame
should normally light up within the rst one or two seconds.
Lighting up using a BBQ lighter
• When starting cold, the appliance may be lit from the top prior to tting the desired cooking surface onto the fat pan. When lighting
up a hot appliance however, it is recommended that this be done by sticking barbecue lighter through one of the Vent Holes
underneath the Burner, until it is in line with the burner(DO NOT place the BBQ lighter through the large hole directly underneath the
burner). Ignite the BBQ lighter. Whilst the BBQ lighter is lit, push in and turn the control knob anti-clockwise to light the burner.
General
• Once the appliance is lit, the ame intensity may be adjusted by turning the valve knob anti-clockwise to reduce the ame, or
clockwise to increase the ame.
• The fully closed position is at the furthest clockwise position. To rotate the valve from the fully closed position it is necessary to rst
depress the knob just enough to move out of the lock mechanism. While holding the knob in, turn it in an anti-clockwise direction.
Once the spindle has moved out of the lock position it is no longer necessary to keep the control knob depressed and it can be rotated
freely to the desired ame setting.
• When cooking food with a high fat content, aring may occur if the selected heat setting is too high. Should this happen, turn the heat
down until the aring ceases.
Fig. 10
GB

Chatee con su manual de Cadac Citi Chef 50 usando IA

Obtenga respuestas instantáneas de IA de su manual de Cadac Citi Chef 50

Pregunte lo que quiera sobre Cadac Citi Chef 50. Las respuestas provienen de este manual, con las páginas en las que se basan.

Citi Chef 50 Programa de mantenimiento

Antes de cada uso
Compruebe la manguera por desgaste o daños

Inspeccione la manguera de gas para detectar señales de desgaste o daños antes de cada uso y antes de conectarla al recipiente de gas. Reemplácela si está dañada.

Mostrar en el manual (página 4)
Después de cada uso
Limpie la bandeja de grasa y la rejilla de BBQ

Retire la grasa del canal en el fondo de la Bandeja de Grasa. Lave la rejilla con agua tibia y detergente no abrasivo después de retirar el exceso de grasa.

Mostrar en el manual (página 9)
Antes de cada conexión
Inspeccione la junta del regulador

Asegúrese de que la junta del regulador esté en su posición y en buenas condiciones antes de colocarlo en un recipiente de gas. Hágalo con cada conexión.

Mostrar en el manual (página 6)
Según sea necesario
Reacondicione las superficies de cocción de cerámica

Después de limpiar, reacondicione las superficies antiadherentes de cerámica con una ligera aplicación de aceite vegetal. Utilice solo utensilios de plástico o madera para evitar daños.

Mostrar en el manual (página 9)
M: qwen/qwen3.8-flash

Haz una Pregunta

0/1000

¿Recomiendas Citi Chef 50?

Sí No

Preguntas frecuentes

A

No, este aparato está diseñado solo para uso exterior. Requiere ventilación significativa para operar de manera segura y eficiente. Usarlo en espacios cerrados como balcones o porches es peligroso y está prohibido.

¿Esta respuesta fue útil?

A

Puede usar contenedores de gas recargables de hasta 9kg que cumplan con las regulaciones locales. La altura del cilindro no debe exceder los 500mm y el ancho 350mm. Los requisitos específicos de presión varían por región (por ejemplo, 28-30 mbar o 50 mbar).

¿Esta respuesta fue útil?

A

Si el encendedor piezoeléctrico falla, puede encender el quemador manualmente usando un encendedor de barbacoa. Inserte el encendedor a través de los orificios de ventilación debajo del quemador hasta que se alinee con el quemador, luego gire la perilla de control para encenderlo.

¿Esta respuesta fue útil?

A

No, la piedra para pizza es un accesorio opcional vendido por separado. Es una piedra de horneado de 10mm de grosor capaz de soportar temperaturas de hasta 500 grados Celsius y viene con un soporte de alambre plateado.

¿Esta respuesta fue útil?

A

Debe revisar todas las conexiones en busca de fugas antes de cada uso. Use agua jabonosa en las juntas; si se forman burbujas, hay una fuga. Cierre inmediatamente el suministro de gas e inspeccione los accesorios.

¿Esta respuesta fue útil?

A

Para proteger el recubrimiento cerámico antiadherente, debe usar utensilios de plástico o madera. Los utensilios de metal pueden rayar y dañar permanentemente la superficie, anulando la efectividad de la capa antiadherente.

¿Esta respuesta fue útil?

M: QW-35-FL

Ventajas y Desventajas

Ventajas

  • Alta salida de calor de 3.7 kW para una cocción rápida y eficiente
  • Diseño modular soporta múltiples superficies de cocción intercambiables
  • Sistema de encendido piezoeléctrico asegura un encendido confiable y fácil
  • Recubrimientos cerámicos antiadherentes duraderos en accesorios disponibles
  • Garantía del fabricante de cinco años contra defectos de fábrica
VS

Desventajas

  • Estrictamente limitado al uso exterior debido a los requisitos de ventilación
  • El cilindro de gas y la manguera deben comprarse por separado en la mayoría de las regiones
  • Las superficies cerámicas pueden dañarse por utensilios de metal si no se tiene cuidado
  • Requiere revisiones de mantenimiento regulares para inyectores y ventilaciones
  • El mango del domo puede volverse muy caliente durante el uso prolongado
M: QW-35-FL

Producto Especificación

Tipo

Carro de parrilla

Potencia

3,5 kW

Número de quemadores

1

Quemador

1 quemador principal

Accesorios para asar

Rejilla de parrilla (aluminio, recubrimiento antiadherente), tapa de parrilla con termómetro

Área de cocción

46 cm (diámetro), 0,17 m² (área)

Consumo de gas

270 g/h

Áreas de estante

2 estantes laterales (extraíbles, madera), debajo del gabinete, gabinete para botella de gas, 2 ganchos para cubiertos

Características

Ruedas, contenedor de recolección de grasa

Dimensiones

860x1023x550 mm (AnxAxPr)

Peso

20,00 kg

M: QW-35-FL

Producto Descripción

Experimente la Cocina Exterior Definitiva con Cadac Citi Chef 50

El Cadac Citi Chef 50 representa la cúspide de la cocina exterior portátil, diseñada específicamente para aquellos que desean vivir la vida braai en cualquier lugar. Este aparato versátil transforma patios, campamentos y jardines en cocinas gourmet. Su construcción robusta asegura durabilidad mientras mantiene un perfil elegante que se adapta fácilmente a cualquier entorno exterior.

En el corazón del Citi Chef 50 está su potente entrada de calor de 3.7 kW, capaz de ofrecer rendimiento constante ya sea que esté asando carne, pescado o verduras. La unidad cuenta con una válvula ajustable que permite a los usuarios controlar la intensidad de la llama con precisión, asegurando resultados perfectos cada vez. El sistema de encendido piezoeléctrico hace que encender el quemador sea sencillo, incluso en condiciones ligeramente húmedas, siempre que se tomen las precauciones adecuadas.

Una de las características destacadas de esta parrilla es su modularidad. El Citi Chef 50 admite una amplia gama de superficies de cocción opcionales, incluyendo una rejilla de barbacoa cerámica antiadherente, una sartén de chef, una bandeja de asado esmaltada y una piedra para pizza. Cada accesorio está diseñado para mejorar sus capacidades culinarias, permitiéndole preparar todo, desde filetes sellados hasta pizzas crujientes. Los recubrimientos cerámicos en estas superficies aseguran una limpieza fácil y un rendimiento duradero cuando se usan utensilios de madera o plástico.

La seguridad es primordial en el diseño del Cadac Citi Chef 50. Está estrictamente destinado solo para uso exterior, requiriendo ventilación adecuada para evitar la acumulación de monóxido de carbono. El aparato incluye mecanismos de seguridad como un domo escudo contra el viento, que no solo protege la llama sino que también sirve como tapa de cocción. Se aconseja a los usuarios mantener distancias seguras de materiales inflamables y verificar siempre mangueras y reguladores antes de cada uso. La unidad opera con cilindros de gas aprobados de hasta 9kg, cumpliendo con varias normas internacionales según la región de uso.

El mantenimiento es sencillo, colocando la responsabilidad en el consumidor. La limpieza regular de la bandeja de grasa y las rejillas, junto con revisiones ocasionales del inyector y el venturi, mantiene la unidad funcionando suavemente. El fabricante ofrece una garantía de cinco años contra defectos de fábrica, proporcionando tranquilidad para una inversión a largo plazo. Ya sea que sea un maestro de la parrilla experimentado o un principiante, el Cadac Citi Chef 50 ofrece la flexibilidad y el poder necesarios para elevar su experiencia de comedor al aire libre.

Notas Importantes

  • Siempre use guantes protectores al manipular superficies calientes.
  • Asegúrese de que el cilindro de gas esté vertical durante la operación.
  • Use solo accesorios genuinos de CADAC para mantener la validez de la garantía.
M: QW-35-FL

© Copyright 2026 Manual.ly